1) Message boards : Questions and problems : BOINC and quake catcher (Message 94293) Posted 16 Dec 2019 by timwebb2 Post: thanks for your advice, I will do this.

2) Message boards : Questions and problems : BOINC and quake catcher (Message 94277) Posted 15 Dec 2019 by timwebb2 Post: update to my last post, it comes up with "demo mode, sensor not found" when I run BOINC, However I know the sensor has been installed with the correct drivers and runs QCNlive.

3) Message boards : Questions and problems : BOINC and quake catcher (Message 94276) Posted 15 Dec 2019 by timwebb2 Post: thanks, does this mean I need to "point" BOINC towards my graphics card? Or is there more to it than that? I have tried 3 PC's (all on Windows 7) and none seem to run the full BOINC sensor graphics and indicate that the graphics are in demo mode. It does not seem to recognise the sensor, so it a problem with recognising the sensor perhaps? (rather than the graphics card?) However when I try QCNlive the sensor is recognised and it produces graphics. So I guess I will stick to this ....... thanks, regards, Tim

4) Message boards : Questions and problems : BOINC and quake catcher (Message 94137) Posted 10 Dec 2019 by timwebb2 Post: any advice as to how I can see the graphics for my Joytech sensor? I see the spinning globe but the sensor graphics say in demo mode. I know the sensor works as I can see the graphics in the QCN live interactive software but not in BOINC. thanks, regards, Tim

---

Copyright © 2024 University of California.
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation.