Message boards : Documentation : client_state.xml - documentation
Message board moderation
Author | Message |
---|---|
Send message Joined: 3 Nov 06 Posts: 19 |
I looking for an explanation of all (or the most) of the parameters in the client_state.xml file. Is there a web page or ...... ? Is there anyone who can help me ? |
Send message Joined: 12 Feb 06 Posts: 232 |
Which seems to have been copied from the trac wiki, which is a better source. See http://boinc.berkeley.edu/trac/wiki/ClientData -- Eric Myers "Education is not the filling of a pail, but the lighting of a fire." -- William Butler Yeats |
Send message Joined: 3 Nov 06 Posts: 19 |
thanks to Sekerob and Myers. But I think there is very, very little information in the pages you submitted Anyway, again many thanks |
Send message Joined: 12 Feb 06 Posts: 232 |
You are right, it is not a complete page. But hopefully it helps a little. The client_state.xml should not be that hard to read once you get the hang of reading the XML. The tag names describe what they contain. To figure out what the contents mean you may have to dig a bit deeper into the documentation, but you can decide which parts you wish to investigate deeper. There are several sources of documentation. The trac wiki I linked to above is for the developers and project administrators, so it is more terse and technical. The User's Guide is for the client and those who run the client on their own computers, and ideally it is more accessible and detailed. Though we are not there yet. So we could start a page in the User's Guide about the client_state.xml file, and fill it in over time and with the help of many volunteers. This would be similar to the already existing page on Client configuration, which describes the contents of the cc_config.xml file. ...I just started the page: Client state. Please, anybody who can, help make BOINC documentation better by filling it in. -- Eric Myers "Education is not the filling of a pail, but the lighting of a fire." -- William Butler Yeats |
Send message Joined: 3 Nov 06 Posts: 19 |
Ok Eric ! I think you must add another section: Active Tasks Set This section is at the bottom of the file. After that section there is also other general information I think the next step may be the brute list of all the parameters. I haven't yet worked with Wiki, may be this is the first time I use it. By the way, I have a big problem: I'm not so fluently with english, I'm italian My specific interest was for : duration correction factor short/long term debt |
Send message Joined: 12 Feb 06 Posts: 232 |
The nice thing about the wiki is that we can start work on the page and flesh it in slowly. And you don't have to do all the work, we can spread that out too. And there are other sources of documentation where we can get some help. A good one for definitions is the BOINC FAQ Service -- Eric Myers "Education is not the filling of a pail, but the lighting of a fire." -- William Butler Yeats |
Copyright © 2024 University of California.
Permission is granted to copy, distribute and/or modify this document
under the terms of the GNU Free Documentation License,
Version 1.2 or any later version published by the Free Software Foundation.