Message boards :
BOINC Manager :
xlib errors
Message board moderation
Previous · 1 · 2
Author | Message |
---|---|
Send message Joined: 16 Apr 06 Posts: 386 |
Not really adding anything interesting to this thread, but I've got it on my openSUSE 10.3 32-bit system with 5.10.21. Set up the 'remote control' stuff so that I could run the manager from my windows box instead, and that worked fine. Haven't tried experimenting with different versions since I found a solution that worked for me. I'll be changing to openSUSE 10.3 64-bit sometime next week in any case, and I'll use the same remote control setup if the problem still persists. |
Send message Joined: 11 Oct 07 Posts: 2 |
I did the same as MikeMarsUK now, and it works. I control the client from my windows machine, and it runs fine. But i would prefer to be able to start the manager on the linux box, too. |
Send message Joined: 10 Oct 07 Posts: 5 |
BOINC 6.0 ??? Me very currious :-) |
Send message Joined: 16 Apr 06 Posts: 386 |
These pages have some info about version 6. http://boinc.berkeley.edu/trac/wiki/VersionSixPortal http://boinc.berkeley.edu/trac/milestone/6.0 http://boinc.berkeley.edu/trac/wiki/ClientSetupLogicWinSix |
Send message Joined: 10 Oct 07 Posts: 12 |
From the German planet3D forum I learned this thread: http://en.opensuse.org/Xlib.lock After executing it, the 5.10.8 GUI ran again Berend |
Copyright © 2024 University of California.
Permission is granted to copy, distribute and/or modify this document
under the terms of the GNU Free Documentation License,
Version 1.2 or any later version published by the Free Software Foundation.